由于自動變速箱的電子元件非常復雜,所以在維修時也比較困難和不方便,下面網絡就詳細介紹一下濟南自動變速箱維修的基本知識。
Because the electronic components of the automatic gearbox are very complex, it is also difficult and inconvenient to maintain. The following network will introduce the basic knowledge of Jinan automatic gearbox maintenance in detail.
經常檢查自動變速箱油位計是否正常。
Always check whether the automatic transmission oil level gauge is normal.
檢查自動變速箱油和機油,機油冷卻條件下的汽車檢驗,和傳動油是熱油至50℃,然后在每個齒輪鏈節流2秒后塊停車的地方,然后油尺和正常油位應位于中間,如不足,應立即用同樣的成品油的質量。
Check the automatic transmission oil and engine oil, check the vehicle when the engine oil is cooled, and the transmission oil is hot oil to 50 ℃, then stop at the place where each gear link flows for 2 seconds, and then the dipstick and normal oil level should be in the middle, if not enough, immediately use the same product oil quality.
正確清除傳動油。
Remove the transmission oil properly.
在目前階段,改變油是動態變化的好辦法,清潔機械特殊傳動的使用,在傳輸操作的整個過程中,舊的油足夠的循環系統,清潔污水,然后添加新變速器油,然后把油90以上,以確保石油很好的實際效果。
At present, changing the oil is a good way of dynamic change. Clean the use of special mechanical transmission. In the whole process of transmission operation, the old oil has enough circulation system, clean the sewage, then add new transmission oil, and then put the oil above 90 to ensure the good actual effect of oil.
掌握自動變速箱除油更換的周期時間。
Master the cycle time of oil removal and replacement of automatic transmission.
自動變速箱內部控制系統的組織精度非常高,與對方的間隙很小,所以絕大多數廠家建議自動變速箱的油循環時間一般為2年或4 ~ 6萬公里。在正常使用的整個過程中,傳動油的工作溫度一般在120℃左右,所以成品油的質量非常高,必須保持清潔。第二,齒輪箱長期使用機油會引起機油,可能產生機油,會增加摩擦,損壞各部件,還會損害系統軟件的蒸汽壓力,傳動力受到影響。三、臟油中的油會使閥體在閥體內的運動不自由,蒸汽壓力控制受到影響,然后自動變速箱發現異常。
The internal control system of the automatic gearbox has a very high organization accuracy and a very small gap with the other side. Therefore, most manufacturers recommend that the oil circulation time of the automatic gearbox is generally 2 years or 40000-60000 km. In the whole process of normal use, the working temperature of transmission oil is generally around 120 ℃, so the quality of product oil is very high, and it must be kept clean. Second, the long-term use of the gearbox oil will cause oil, which may generate oil, increase friction, damage various components, damage the steam pressure of the system software, and affect the transmission power. 3、 The oil in the dirty oil will make the movement of the valve body in the valve body not free, the steam pressure control will be affected, and then the automatic transmission will find the abnormality.
以上是
濟南自動變速箱維修公司小編為大家介紹的相關內容,想要了解更多內容,歡迎訪問網站:http://njzhuiri.cn
The above is the relevant content introduced by Jinan automatic transmission maintenance company. To learn more, please visit the website: http://njzhuiri.cn