制動盤材質的硬度要比制動片高,所以在正常使用條件下更換頻率沒有那么快。但也需要車主經常性的檢查,自動變速箱維修提醒您如果您發現制動盤表面因過度銹蝕而出現大面積的凹槽,車主應該及時更換,過度銹蝕還會導致剎車片嚴重?fù)p壞,剎車失靈。
The hardness of the brake disc material is higher than that of the brake disc, so the replacement frequency under normal operating conditions is not so fast. But also need the owner of regular inspection, automatic transmission maintenance reminds you if you find that the surface of the brake disc due to excessive rust and large area of groove, the owner should be replaced in time, excessive rust will also lead to serious damage to the brake pad, brake failure.
車輛制動應該合理利用車速和擋位控制速度,這樣可有效延長制動系統的使用壽命。制動系統在日常使用中,車主應該注意控制溫度,不要連續大力使用剎車,這樣會導致制動盤、片的溫度快速升高,甚至可能引起剎車片燃燒,或剎車油沸騰,這都將引起剎車失效、故障的發生。

Vehicle braking should reasonably use the speed and gear control speed, which can effectively prolong the service life of the braking system. In the daily use of the brake system, the owner should pay attention to the control of the temperature, do not continue to use the brake vigorously, this will lead to rapid increase in the temperature of the brake disc, disc, or even may cause brake disc combustion, or brake oil boiling, which will cause brake failure, failure.
有經驗的駕駛員通常會給自己保留一定的反應時間和距離。特別在遇到紅燈和下坡時,預先將車速降低并利用合適的擋位,通過發動機制動配合制動系統的操作方式,可有效降低制動系統的負擔,避免制動系統發生過熱現象。
Experienced drivers usually keep a certain reaction time and distance to themselves. Especially in the case of red lights and downhill, the speed will be reduced in advance and the use of appropriate gear, through the engine braking with the braking system operation mode, can effectively reduce the burden of the braking system, avoid the braking system overheating phenomenon.
自動變速箱維修廠家提醒各位車主在檢測時發現剎車液降低達到較低限度,應該及時進行補充。如果剎車液比前一次檢查大量減少時,車主要立刻到4S店或維修廠進行檢修。
Automatic transmission maintenance manufacturers remind owners in the detection of brake fluid found to reduce to a minimum, should be timely replenishment. If the brake fluid is much less than the previous inspection, the owner should immediately go to the 4S shop or repair shop for repair.